Is the Quick connector plug for injection molds with GW without valve, DYROS series 30 compatible with standard BSP-threaded cooling lines and fittings?

Yes. The Quick connector plug for injection molds with GW without valve, DYROS series 30 features an internal BSP thread, so it is compatible with standard BSP-threaded cooling lines and fittings. Its brass construction and 15 bar working pressure make it suitable for cooling liquids in plastic processing and similar technical applications. Ensure thread size matches your existing BSP components for proper sealing and performance.

Can the Quick connector plug for injection molds with GW without valve, DYROS series 30 withstand short-term pressure surges up to 15 bar in cooling circuits?

Yes. The Quick connector plug for injection molds with GW without valve, DYROS series 30 is specified with a working pressure of 15 bar, is made of brass, and is designed for cooling liquids in plastic processing. Based on this specification, it can withstand short-term pressure surges up to 15 bar in cooling circuits. Ensure the installation and mating coupling are rated similarly and that temperature, fluid type and dynamic effects do not create additional stresses beyond the specified rating.

Does the Quick connector plug for injection molds with GW without valve, DYROS series 30 require specific tightening torque for BSP installation?

Quick connector plug for injection molds with GW without valve, DYROS series 30 does not specify a unique or special tightening torque for BSP installation in the provided product description. The description only gives function, material (brass) and working pressure (15 bar) and does not include a recommended torque value. Practical advice: - Follow standard BSP thread installation practice for brass fittings to avoid damage or leaks. - Use appropriate thread sealant (PTFE tape or liquid sealant) rated for the media and temperature. - Hand-tighten, then apply a wrench torque consistent with the fitting size and brass materialâtypically moderate torque to avoid thread deformation. For specific torque values consult: - Manufacturerâs detailed technical datasheet or installation guide for Quick connector plug for injection molds with GW without valve, DYROS series 30. - General BSP torque reference charts for brass fittings based on thread size. - If critical (high safety, high temperature, frequent disconnection), contact the manufacturer or supplier for exact recommended tightening torque. If you want, I can look up typical BSP torque charts and give approximate torque ranges based on thread size.

Quick connector plug for injection molds with GW without valve, DYROS series 30

Additional information

Material	B – brass (bronze)

DYROS series 30 quick coupling plug with internal BSP thread without valve. Designed for cooling liquids in plastic processing, compressed air installations, gas cylinder applications, and other technical fields. Material: brass. Working pressure: 15 bar.

List of product variants

Article number	Product variant name	Nominal inner diameter	Working pressure [bar]
DY-NI314	DN 6 plug with 1/4" female thread, without valve	-	15
DY-NI318	DN 6 plug with G 1/8", without valve	-	15
DY-NI338	DN 6 plug with G 3/8", without valve	-	15

DYROS series 30 quick coupling plug with internal BSP thread without valve. Designed for cooling liquids in plastic processing, compressed air installations, gas cylinder applications, and other technical fields. Material: brass. Working pressure: 15 bar.