Is the Elbow 90Â° with BSP GZ, brass, type EW rated for continuous use at 63 bar and temperatures between -10Â°C and +90Â°C?

Yes. Elbow 90Â° with BSP GZ, brass, type EW is rated for continuous use at up to 63 bar and in the temperature range from â10Â°C to +90Â°C, per the provided specifications. Continuous operation within those stated working pressure and operating temperature limits is acceptable; do not exceed 63 bar or operate outside â10Â°C to +90Â°C.

Can Elbow 90Â° with BSP GZ, brass, type EW withstand sudden pressure spikes above 63 bar or only steady-state pressures?

Elbow 90Â° with BSP GZ, brass, type EW Format is specified with a working pressure âup to 63 barâ and an operating temperature range of -10Â°C to +90Â°C. That rating normally refers to steady-state (continuous) working pressure under the stated temperature conditions. It does not guarantee resistance to sudden pressure spikes (pressure transients, water hammer) above 63 bar. Brass fittings can fail if exposed to short-term overpressure beyond their rated limit, especially at thread joints or thin sections. For applications with possible pressure spikes exceedÂing 63 bar, use a component rated for higher maximum pressure or install surge protection (accumulators, pressure relief valves, dampers). If confirmation is required for a specific transient profile, consult the manufacturer or obtain a fitting with explicit transient/impact pressure ratings.

Does Elbow 90Â° with BSP GZ, brass, type EW require any special maintenance at 63 bar and -10Â°C to +90Â°C?

No special maintenance is required for Elbow 90Â° with BSP GZ, brass, type EW when used within the specified limits (working pressure up to 63 bar and operating temperature from â10Â°C to +90Â°C). Standard preventive care will ensure reliable performance: - Inspect periodically for visible damage, corrosion or wear, especially at the threaded joint. - Ensure proper thread sealing (use appropriate tape or sealant compatible with brass and the media). - Tighten to recommended torque to avoid leaks or overtightening; avoid excessive mechanical stress on the elbow or connected piping. - If used with aggressive media or in corrosive environments, increase inspection frequency and consider compatible coatings or alternative materials. - Protect against temperatures and pressures exceeding the stated ratings; rapid temperature cycling may warrant more frequent checks. - Keep fittings clean and free of debris during installation to prevent contamination. Following these routine measures will maintain safe operation of Elbow 90Â° with BSP GZ, brass, type EW under the given conditions.

Elbow 90° with male thread BSP, brass, type EW

Additional information

Material	B – brass (bronze)

Elbow 90° brass with a thread external BSP. Material: brass. Working pressure: up to 63 bar. Operating temperature: from -10°C to +90°C.

List of product variants

Article number	Product variant name	DN	BAR	Availability	Actions
EW-MS-18582	Elbow 90° with 1/8" BSP male, brass	-	63	In stock	Enquiry
EW-MS-18583	Elbow 90° with 1/4" BSP male, brass	-	63	In stock	Enquiry
EW-MS-18585	Elbow 90° with 3/8" BSP male, brass	-	63	In stock	Enquiry
EW-MS-18587	Elbow 90° with 1/2" BSP male, brass	-	63	In stock	Enquiry
EW-MS-18588	Elbow 90° with 3/4" BSP male, brass	-	63	In stock	Enquiry
EW-MS-18589	Elbow 90° with 1" BSP male, brass	-	63	In stock	Enquiry