Is the Copper washer for UHP, 2000 bar compatible with quick couplings and adapters with external threads for use up to 2000 bar?

Yes. Copper washer for UHP, 2000 bar Format is designed for use in high-pressure installations and explicitly intended for quick couplings and adapters with external threads. It is compatible for use up to 2000 bar, provided the mating components (couplings/adapters) are rated for that pressure and properly installed. Ensure correct washer size and surface finish, clean sealing faces, and follow recommended torque values for the threaded connection to achieve a reliable seal at up to 2000 bar.

Can the Copper washer for UHP, 2000 bar withstand repeated high-pressure cycles in quick couplings and threaded adapters?

Yes. The Copper washer for UHP, 2000 bar is designed for repeated high-pressure cycles in quick couplings and threaded adapters. Made for use in high-pressure installations up to 2000 bar, its copper material provides good elasticity and sealing recovery under cyclic loading, while resisting cold flow and deformation when properly compressed within the correct groove or mating surface. For reliable repeated use, ensure correct installation, compatibility with the specific coupling/adapter dimensions, and adherence to maximum pressure and temperature ratings; inspect washers regularly and replace if any signs of flattening, cracking, or leakage appear.

Does the Copper washer for UHP, 2000 bar require specific torque settings when fitted to quick couplings or adapters?

Copper washer for UHP, 2000 bar Format: The Copper washer for UHP, 2000 bar is designed as a soft sealing element for highâpressure quick couplings and adapters with external threads, rated up to 2000 bar. As a sealing component, it does not have a single universal torque value applicable to all installations. Correct torque depends on the specific coupling/adapter design, thread size, material, and manufacturer's recommendations to ensure proper compression of the copper washer without overstressing threads or deforming sealing faces. General guidance: - Always follow the torque specification provided by the quick coupling or adapter manufacturer when available. - If manufacturer torque is not specified, tighten to a controlled torque sufficient to compress the washer into a leakâtight seal while avoiding thread damage. typically moderate handâtorque plus a defined additional wrench turn for small fittings, or a torque value derived from thread size charts validated by testing. - Use a calibrated torque wrench and assemble under clean, undamaged conditions; replace the copper washer after disassembly. - After initial assembly, pressureâtest the joint at working pressure or a recommended test pressure to confirm sealing; if leakage occurs, incrementally increase torque within safe limits or replace components as needed. - For critical or safetyâsensitive systems, consult the coupling/adapter manufacturer or a qualified engineer to determine exact torque settings and assembly procedure. In summary, the Copper washer for UHP, 2000 bar requires appropriate torque for effective sealing, but the exact torque must be determined from the coupling/adapter manufacturer's specifications or by validated testing rather than a single universal value.