Can the T-piece for coolant distribution system, 1/4" system, LOC-LINEÂ® withstand continuous operation at working pressure up to 3 bar and temperature up to +76Â°C?

Yes. The T-piece for coolant distribution system, 1/4" system, LOC-LINEÂ® is made of acetal and is specified for continuous operation at working pressures up to 3 bar and operating temperatures up to +76Â°C, so it can withstand those conditions.

Is the T-piece for coolant distribution system, 1/4" system, LOC-LINEÂ® compatible with acetal material under 3 bar and +76Â°C continuous use?

Yes. T-piece for coolant distribution system, 1/4" system, LOC-LINEÂ® is compatible with acetal material for continuous use up to 3 bar and +76Â°C, matching the specified working pressure and operating temperature limits.

Does the T-piece for coolant distribution system, 1/4" system, LOC-LINEÂ® resist occasional pressure spikes above 3 bar?

T-piece for coolant distribution system, 1/4" system, LOC-LINEÂ® Format is specified with a working pressure âup to 3 bar.â That rating means the fitting is rated for continuous and typical intermittent use at or below 3 bar. Occasional pressure spikes above 3 bar are not covered by that rated working pressure and therefore cannot be guaranteed safe by the manufacturer. Short, minor spikes slightly above 3 bar may not immediately cause failure depending on spike magnitude, duration and system conditions (temperature, previous wear, installation quality), but doing so increases risk of leaks, deformation or sudden breakage of the acetal fitting. For safe and reliable operation you should either limit system pressures to â¤3 bar, fit a pressure relief or damping device to mitigate spikes, or select fittings rated for higher pressures if your system can exceed 3 bar even occasionally.

T-piece for coolant distribution system, 1/4″ system, LOC-LINE®

Air and water hoses, All products/

Additional information

Material	P – material (plastic)

Tee fitting for creating a coolant distribution system LOC-LINE® – 1/4″ system. Material: acetal. Working pressure: up to 3 bar. Operating temperature: up to +76°C.

List of product variants

Article number	Product variant name	DN	BAR	Availability	Price	Quantity	Actions	Catalogue
LL-49436	Tee for distribution system (1/4" system)	-	3	In stock	0 zł		Enquiry

Do you need a larger quantity of products or a bespoke quote?

Call us: +48 61 653 02 22 or email us: tubes@tubes-international.com

SEND ENQUIRY

Tee fitting for creating a coolant distribution system LOC-LINE® – 1/4″ system. Material: acetal. Working pressure: up to 3 bar. Operating temperature: up to +76°C.