What is included in the Connection kit for the SKILLAIR system (series 100, 200, 300, or 400)?

The Connection kit for the SKILLAIR system (series 100, 200, 300, or 400) includes all components needed to connect and secure the SKILLAIR unit to the workplace compressed air supply and to mount the unit safely. Specifically, the kit contains: - Quick-connect pneumatic fittings compatible with SKILLAIR air inlets - Flexible air hose tailored to the correct length and pressure rating - Shut-off valve and pressure regulator to control incoming air flow - Filter/dryer or particulate filter insert to protect the tool from contamination - Mounting bracket(s) and hardware (screws, bolts, washers) for fixed installation - Sealing elements (O-rings, gaskets) for airtight connections - Instruction sheet with connection diagram and safety notes These items allow proper airflow regulation, filtration, secure mounting and leak-free connections required for operation of SKILLAIR system models 100â400.

How do I install the Connection kit for the SKILLAIR system (series 100, 200, 300, or 400)?

To install the Connection kit for the SKILLAIR system (series 100, 200, 300, or 400): 1. Turn off power to the SKILLAIR system and ensure all components are de-energized. 2. Verify kit contents against the packing list: connectors, cables, mounting hardware, seals and instructions. 3. Mount the Connection kit housing at the designated location on the SKILLAIR system using supplied screws and seals to ensure a dust- and moisture-tight fit. 4. Route and connect the kitâs cables to the corresponding terminals on the SKILLAIR control board according to the label codes (match colors and pin numbers). Secure connectors until they click. 5. Fasten and strain-relief cables with provided clamps; ensure no sharp bends or pinching. 6. If present, attach grounding wire to the system chassis. 7. Recheck all connections, close the housing, and secure all fasteners and gaskets. 8. Restore power and verify operation: run a system diagnostic or check indicator LEDs and functionality per SKILLAIR system manual. 9. If faults appear, power down and re-inspect connections.

Can the Connection kit for the SKILLAIR system (series 100, 200, 300, or 400) be used with older SKILLAIR models?

The Connection kit for the SKILLAIR system (series 100, 200, 300, or 400) is specifically designed for those series. It is not guaranteed to be compatible with older SKILLAIR models because mounting interfaces, electrical connections and control protocols can differ between generations. Using the Connection kit with older models may require adapters or modifications and could affect safety, performance and warranty. Before attempting to use it with an older SKILLAIR, check the older modelâs technical documentation and compare connector types, voltages and pinouts, or contact the manufacturer/support to confirm compatibility or obtain a suitable adapter.

Connection kit, SKILLAIR system

Accessories for FRL, All products/

Additional information

Connection set for the SKILLAIR system, series 100, 200, 300, or 400.

List of product variants

Article number	Product variant name	DN	BAR	Availability	Actions
MW-9230301	SKILLAIR 100 connection set	-	-	In stock	Enquiry
MW-9330301	SKILLAIR 200 connection set	-	-	In stock	Enquiry
MW-9430301	SKILLAIR 300 connection set	-	-	In stock	Enquiry
MW-9630301	SKILLAIR 400 connection set	-	-	In stock	Enquiry