Our products
Select options This product has multiple variants. The options may be chosen on the product page / DetailsHand, light device for bending pipes o diameter od 8 for 22 mm. set contains roll bending and sheet-metal, strength case. Dla increasing precision bending roll equipped in scale value angles. greater roll applied are on smaller thanks to this set is lighter. device adapted for mounting in vice. weight: 14 kg.- Select options This product has multiple variants. The options may be chosen on the product page / DetailsDevice intended for machining finishing ends pipes po cutting (removal burrs with outer and internal edge). intended for pipes made both of carbon steel as and steel stainless. Maximum Diameter tubes: 42 mm. Voltage: 230 V. Moc: 0.18 kW. speed: 50 obr/min. weight: 30 kg.
- Select options This product has multiple variants. The options may be chosen on the product page / DetailsRoller for bending pipes hydraulic metric o diameters external 6, 8, 10, 12, 14, 15, 16, 18, 20, 22, 25, 28, 30, 32, 35, 38 and 42 mm Intended for equipment: CM42, CMS42, C42, MINI CENTER and CENTER JUNIOR.
- Select options This product has multiple variants. The options may be chosen on the product page / DetailsVery straight, hand device for bending pipes hydraulic in the scope diameters external 6 ÷ 18 mm intended for small workshops. W set roll bending and durable sheet-metal Case. device adapted for mounting in vice (vice not is in set). weight: 10 kg.
- Select options This product has multiple variants. The options may be chosen on the product page / DetailsDevice with manual two-stage pump hydraulic and switch end for bending pipes hydraulic in the scope diameters external 6 ÷ 42 mm (Wall thickness for 4 mm) made of carbon steel and stainless. cooperate with tools bending (ordered separately). version adapted for mounting in vice. weight: 40 kg.
- Select options This product has multiple variants. The options may be chosen on the product page / DetailsDevice for bending pipes hydraulic in the scope diameters external 6 ÷ 42 mm (Wall thickness for 4 mm) with manual two-stage pump hydraulic. has metal base with container on tools. Compatible with tools bending (ordered separately). weight: 48 kg.
- Select options This product has multiple variants. The options may be chosen on the product page / DetailsSemi-automatic device for bending pipes hydraulic with pump hydraulic o drive electric. The design and principle operation consisting on wrapping tubes on rotating template. device controlled electronically with built-in panel allows achieving precise bending. Po pressing button „start” on panel control The machine independently bends pipe o set angle without additional interference of side the operator. optionally Available double pedal electric with switch safety. tools (templates), on which bent is pipe ordered separately (18 sizes). range bending pipes: 6 ÷ 50 mm (Wall thickness 3 mm). supply: 400 V, 50/60 Hz, 1.1 kW. maximum angle bending: 180°. speed bending o angle 90°: 6 seconds. accuracy bending: ±1°.
