What is the torque specification for installing the Pneumatic cylinder piston rod nut, model S, on piston rods Ã32â125 mm?

Pneumatic cylinder piston rod nut, model S . for piston rods Ã32â125 mm . typical recommended tightening torque depends on rod diameter and thread size. General guidance (approximate values): - Ã32 mm (thread M10âM12): 25â45 Nm - Ã40â50 mm (thread M12âM16): 45â90 Nm - Ã63 mm (thread M16âM20): 90â160 Nm - Ã80â100 mm (thread M20âM24): 160â300 Nm - Ã125 mm (thread M24âM30): 300â600 Nm Use the specific thread size and nut material to choose within these ranges. Always apply Loctite or specified locking method if recommended, tighten to the lower value first then recheck after initial cycle. If available, follow manufacturerâs exact torque table for Pneumatic cylinder piston rod nut, model S; if not, verify torque by calculation based on thread pitch, material strength and required preload.

How do I choose the correct Pneumatic cylinder piston rod nut, model S for piston rods Ã32â125 mm to ensure secure fork/joint head attachment?

Pneumatic cylinder piston rod nut, model S Format should be selected by matching the nutâs internal bore and thread to the piston rod diameter and thread pitch (for Ã32â125 mm rods). Verify the rodâs exact diameter and thread standard (metric/coarse or fine) and choose the corresponding S Format size. Ensure the nutâs axial length and flange/profile suit the fork or joint head seating and allow proper clamping torque without thread stripping. Check material and surface finish for corrosion resistance and required strength for the applicationâs load and dynamic cycles. Finally, confirm compatibility with the fork/joint head (clearance, shoulder location) and tighten to the manufacturerâs specified torque; use locking features (lock washer, threadlocker) if recommended.

Can the Pneumatic cylinder piston rod nut, model S be used with rod end bearings for Ã32â125 mm applications?

Yes. The Pneumatic cylinder piston rod nut, model S can be used with rod end bearings (fork/joint heads) for piston rod diameters in the Ã32â125 mm range. Itâs specifically described as a nut for use on the piston rod to secure, e.g., fork/joint heads, for diameters 32 Ã· 125 mm, which matches the Ã32â125 mm application. Ensure compatibility by checking thread type and size on the piston rod and the mounting requirements of the chosen rod end bearings before installation.

A nut piston rod actuator pneumatic, model S

All products, Pneumatic actuators/

Additional information

Standard length [m]	10

A nut for use na piston rod, to lock np. heads fork/articulated (for diameters 32 ÷ 125 mm).

List of product variants

Article number	Product variant name	DN	BAR	Availability	Actions
MW-0950322010	Nut piston rod MOD. S-M10x1.25	-	-	In stock	Enquiry
MW-0950402010	Nut piston rod MOD. S-M12x1.25	-	-	In stock	Enquiry
MW-0950502010	Nut piston rod MOD. S-M16x1.5	-	-	In stock	Enquiry
MW-0950802010	Nut piston rod MOD. S-M20x1.5	-	-	In stock	Enquiry
MW-0951252010	Nut piston rod MOD. S-M27x2	-	-	In stock	Enquiry